ontluchten?

Alle technische informatie, vragen en oplossingen
def92
Berichten: 126
Lid geworden op: 26 Jan 2011, 18:33

ontluchten?

Berichtdoor def92 » 25 Jan 2013, 19:13

beste,

moet je het koelsysteem van een 200 tdi ontluchten nadat de thermostaat vervangen is? Bij vervangen van thermostaat de koelvloeistof niet afgelaten -> wat koelvloeistof uitgelopen en gewoon achteraf bijgevuld. Hoe ontlucht je een 200tdi?

Indien er een luchtbel in het koelsysteem zit, wat kan dit tot gevolg hebben? Te warm worden vd motor?(niet dat ik me zorgen maak want heb nog niet gereden maar uit onwetenheid)

groeten

Gebruikersavatar
RobStewart
Berichten: 2280
Lid geworden op: 15 Mei 2011, 12:04
Locatie: Roger Young Land Rover, Cornwall
Contact:

Re: ontluchten?

Berichtdoor RobStewart » 25 Jan 2013, 22:40

There is no bleeding procedure for the 200Tdi, however this is how to fill the system.

- Remove the radiator filler cap and fill the radiator until the coolant level is just below the filler neck and refit the cap.
- Fill the expansion tank to approximately half full and refit the cap.
- Run the engine until normal operating temperature is attained.
- Allow the engine to cool completely and remove the radiator and expansion tank caps.
- If necessary, top-up the the radiator to just below the filler neck.
- Top-up the expansion tank to about half full.
- Fit both filler caps.

Rob
Aub alleen te reageren in het Nederlands

1949 1,6 Series I
1975 3,5 V8 Range Rover
1989 3,5 V8 Discovery
2010 Td4e GS Freelander 2
2008 Td4 GS Freelander 2 ... yes we now have two :lol: :lol: :lol:


Terug naar “Techniek”



Wie is er online

Gebruikers op dit forum: Geen geregistreerde gebruikers en 28 gasten