rivet eyebrow verwijderen

Alle technische informatie, vragen en oplossingen
lrseries3
Berichten: 43
Lid geworden op: 21 Nov 2011, 11:39

rivet eyebrow verwijderen

Berichtdoor lrseries3 » 05 Jan 2014, 12:23

Hoe haal ik de eyebrows(wielbogen) van een defender td5 eraf zonder die platic rivetten te beschadigen om opnieuw te gebruiken?
Indien dit niet lukt zonder beschadiging , hoe haal ik deze er het snelst/best uit?

groeten rob

Gebruikersavatar
RobStewart
Berichten: 2280
Lid geworden op: 15 Mei 2011, 12:04
Locatie: Roger Young Land Rover, Cornwall
Contact:

Re: rivet eyebrow verwijderen

Berichtdoor RobStewart » 05 Jan 2014, 12:33

In the centre of the plastic rivet (MWC9918PMA) there is a pin which you will just see, normally I tap this inwards with a thin centre punch until it falls out, it will rattle down the inside of the eyebrow and eventually drop on the ground so put a bit of card or something underneath so you can see where it goes. You can then pull the rivet straight out. When you put it back, put the pin back into the hole in the centre, push the rivet in the hole and then lightly tap the pin back in.

MWC9918PMA.jpg


Rob
Aub alleen te reageren in het Nederlands

1949 1,6 Series I
1975 3,5 V8 Range Rover
1989 3,5 V8 Discovery
2010 Td4e GS Freelander 2
2008 Td4 GS Freelander 2 ... yes we now have two :lol: :lol: :lol:


Terug naar “Techniek”



Wie is er online

Gebruikers op dit forum: Geen geregistreerde gebruikers en 27 gasten