achterklep discovery gaat niet meer open

Alle technische informatie, vragen en oplossingen
defenderman
Berichten: 7
Lid geworden op: 14 Feb 2011, 10:51

achterklep discovery gaat niet meer open

Berichtdoor defenderman » 02 Apr 2017, 14:47

De achterklep gaat niet meer open van mijn 10 jaar oude discovery 3,waarschijnlijk zit het stangetje los bij het motortje.
Het motortjes hoor je wel ,maar je komt er aan de binnenkant niet bij omdat je de bekleding niet los krijgt .
Wat kan je doen.

Waterrover
Beheerder
Berichten: 682
Lid geworden op: 08 Mei 2011, 15:49
Locatie: Zoutkamp

Re: achterklep discovery gaat niet meer open

Berichtdoor Waterrover » 02 Apr 2017, 15:36

Naar de dealer, de snelste en eenvoudigste oplossing lijkt mij. ;)

Gebruikersavatar
RobStewart
Berichten: 2280
Lid geworden op: 15 Mei 2011, 12:04
Locatie: Roger Young Land Rover, Cornwall
Contact:

Re: achterklep discovery gaat niet meer open

Berichtdoor RobStewart » 02 Apr 2017, 17:03

... the end of the latch cable has broken off and you will need a new one, part number LR017470.

Now the fun part, as it is a common problem we used to hold competitions to see how fast you could get the rear door open to replace it.

The rules are simple :

- you are not allowed to damage any interior trim
- choose up to 4 tools
- the clock starts ticking when you enter the vehicle from the rear door.
- the clock stops when you open the upper tailgate.

My best time was 1 minute 58 seconds.

It's actually one of my favourite jobs.

So here's how:

You will need

- a broad flat bladed screwdriver
- a smaller flat bladed screwdriver
- a pair of long nosed pliers, preferably the bent ones , telefoon tang i believe you call them
- a sticking plaster

Get into the back load space.
Look where the plastic trim on the lower tailgate follows the line of the window and at the highest point where it starts to curve downwards.
Insert the large screwdriver here and prise the trim upwards and the bekleding downwards until it pops out.
Place the smaller screwdriver into this hole to keep the bekleding from going back in.
Move the large bladed screwdriver to the left and repeat.
You can now pull the bekleding away about 3cms from the top of the tailgate.
Now reach down slightly to the left of the centre line until you find a rectangular recess in the foam inner liner
Press hard until you go through the foam liner.
You can now feel the actuator housing.
Now feel to the right of the housing until you find the cable exiting from the housing.
You now have to press the edge of this housing towards you until it pops off at one side.
Now the end of the cable will be hanging down and you have to feel for it and flick it up towards you.
Now get the pliers onto the cable and give it a tug while pressing the upper tailgate with your head.
The lock will open and you can get out.

Remove your hand and apply the sticking plaster to the 5cm cut on your right hand. :lol: :lol: :lol:

As I said it takes less than 2 minutes from entry to exit.

From there it's a case of removing the bekleding and replacing the latch and cable.

PS ... if the garage tells you the have to cut the bekleding then they also probably will tell you you have to take the body off to do the timing belt.

Rob
Aub alleen te reageren in het Nederlands

1949 1,6 Series I
1975 3,5 V8 Range Rover
1989 3,5 V8 Discovery
2010 Td4e GS Freelander 2
2008 Td4 GS Freelander 2 ... yes we now have two :lol: :lol: :lol:


Terug naar “Techniek”



Wie is er online

Gebruikers op dit forum: Geen geregistreerde gebruikers en 28 gasten