Unless you are good at gynecology the plastic pin holder is almost impossible to get back on the the actuating arm through the slave cylinder hole. The proper way is to remove the gearbox :ohmy:
However, this is not the official way to do it and I would not recommend it ;) ;) but you can drill a hole in the bottom of the bell housing where the actuating arm end comes into contact with the slave cylinder. Through this hole you can then with a punt tang or screwdriver lever the plastic holder over the arm and then secure it with a tie wrap. You can then fill the hole with a rubber plug of suitable size or fill it with kit.
RobStatistieken: Geplaatst door RobStewart — 02 Dec 2012, 11:21
]]>