... the instructions are as follows
... my personal recommendation based on the fact that I have done the job several times (that is more than 30) ... go and pay for someone else to do it and you could pay me anything and I would still say no its a shit job and even with the special tools it's a shit job and then it just gets shittier.
Have Fun
Rob
PS make sure you put the bearing in the correct way round, if you dont and you drive it off the ramp and the ABS lamp comes on then you have the same fun over again and you get to buy a whole new bearing too ...
PPS have you any idea what 400Nm is like to achieve outside of a workshop with hand tools ?
Statistieken: Geplaatst door RobStewart — 10 Mei 2017, 21:49
]]>